Posts

Chosen Solution My iPhone SE is restarted frequently (after about 5 minutes) after I changed the screen. It is refurbished iPhone 5S screen and everything else works fine. I have tried five different screens but the result is the same. Do you have similar problem with iPhone SE? Thank you. So…it’s kind of like SE displays are “backwards compatible” they will work with 5S and SE. However 5S displays may not always work for SE, even if they were manufactured after the SE was released....

Chosen Solution I just replaced my digitizer and now the phone will not start. It shows an orange led in the speaker when charging but that’s the only sign of life it has. Is there a connector I could’ve missed? Any ideas? The screen itself uses a single LCD ribbon cable where the digitizer is together plugged into.** Double check if the LCD ribbon flex cable is plugged in fully.

Chosen Solution After doing a screen assembly replacement my screen now sometimes goes pink with four black lines through it then goes black. It started when charging. It comes back on later and is fine for awhile and then happens again. Please does someone know if the screen assembly I purchased might be faulty? Hello Karismac, Please check Display FPC (Flexible flat cable) cable properly connected to the FPC connector on logic board....

Chosen Solution I need to replace the charge port. Can I just replace the port itself via soldering? Or do i need to replace the entire daughterboard? @snakes202 sure you could solder a new connector. It will probably be more difficult to find a replacement connector and to solder it to the flex than to replace it. Replacement is about $10USD at places like this and others.

Chosen Solution I synchronized my Ipod with spotify which i did’nt realized until all my music in my ipod was gone…Are there any solutions to this big problem i have? If you still have your music in your iTunes library, you can most likely re-sync that to your iPod. Otherwise your music is most likely gone, though you can try Senuti or TuneAid to recover it. Good luck!

Chosen Solution Does anyone know if KES-496 is swappable with KES-490 laser? Both lasers say they are compatible with CUH-1116A, but my model has got 490 in it. However, I’ve already ordered 496 laser like a month ago, will arrive in a week or so. But now I’m afraid it won’t work. BUT what boosts my hopes is that the 490/496 is even used in some later PS3s, so if it is THAT compatible, this might work....

Chosen Solution I just finished replacing the display assembly on an iphone 4 CDMA. I followed the online guide to a “T”. But as I put it back together, i got down to the battery and the back glass wont slide back on. It will if the battery isnt in the phone. But if it is, the back glass panel wont slide properly. Only one side will. I’ve always had a problem with those....

Chosen Solution Hi I have a 2000 Honda Accord about 100000 miles put a transmission from Japan on her she drives fine but when it’s at a stop and I begin to accelerate it jerks like it’s getting back into d4 any help or advice is greatly appreciated thanks in advance p.s is there a possibility the person who swamped my transmission didn’t connect it properly Jose Velazquez this will be difficult since we do not know how the transmission was connected, what got missed (if anything)or how it actually drives....

Chosen Solution I cannot hear anything through my earpiece. any suggestions ? I used the twist technique to fix my speakerphone, excellent suggestion. . tried using soundabout app but didn’t help. Havent done a reset yet. Any help would be greatly appreciated…. Hi, Have you tried using the earphones with the microphone attached. If you can hear then that proves that your reception is OK (your speakerphone probably told you this anyway) It seems as though your receiver is either loose or is faulty and needs to be replaced....

Chosen Solution I’ve plugged in my nook to charge and the green light is lit on the charging cable indicating a full charge but it will not power on The screen may be the problem. Either the screen is not plugged in properly, or that the ribbon cable is not working as it should. Either way, the lcd screen is not recieving video data as it is supposed to. Try asking professionals in your area to help you....

Chosen Solution my phone wont open,it only blink in green and vibrate try holding middle and power button for 10 seconds to reset the phone.. it’s an answer that has been given before and worked for a few people. it’s worth trying the simple solutions first before you tear your phone apart. Sony Ericsson Repair parts Sony Ericsson Xpeia X10 MiNi Touch Screen with Frame SONY Ericsson Xpeia X10 MiNi Pro LCD Screen Found this site that sells it with free shipping www....

Chosen Solution My wifi on my ipod won’t work at all but on my phone it do. I tried resetting my ipod and network settings, turning airplane mode on & off, and other stuff but it still won’t work. Has your iPod been dropped or repaired recently? Has it come into contact with water? The WiFi flex is really delicate and it doesn’t take much to tear. It might also have gotten partially disconnected....

Chosen Solution Hi, I just baught a 3GS 32Gb Iphone and it’s already unlocked but not jailbroken ( no cydia installed ), model number is MC133B and it’s also Old boot. I was wondering if i jailbreak my iphone will it be locked again? and how can i check if it is factory unlocked. Note that the IOS is 4.3.5 and BB 05.16.02. that’s why i’m worried about jailbreaking it coz if it’s locked i will be stuck in this unlockable baseband and i’ll have to upgrade to BB 6....

Chosen Solution I just replaced the charging port on an iPhone 7+ going step by step through the ifixit repair guide. The phone will not charge still. It is possible you have a defective replacement part. Small parts, such as charge ports have high defect rates compared to replacement screens. Ideally you need to try a known-good replacement part. However, if you’re original problem was charging, then you may have a logic board issue, specifically the charge circuit....

Chosen Solution My program mode rotary button is loose and every time I turn the camera on it comes with an error of mode selector. If I slightly rotate the mode selector it works until I turn it off/on again. New same model cameras at Best Buy have a much firmer selector (when rotated to select the program). Can such problem be fixed? @curiousi , Alex, the buttons are replaceable, Links below are to replacement mode dial assy and to camera teardown to aid in replacement of dial(not your exact model)but may show what is involved to access the mode button for replacement....

Chosen Solution Tail lights and flashers all work I believe that is is located under the dash on the steering column and you will see it makes contact with the brake pedal. It does look like a bracket, that wraps around the brake pedal arm. When the brake pedal is pressed down it pushes the cylinder switch together which closes the circuit and makes you brake lights come on. Check your fuses as well as your wiring to the brake light housing....

Chosen Solution After recently replacing my battery with new one I noticed when I put my phone back together and turned it on I wasn’t getting a cellular signal. Everything else worked great aside from that. I Read online that I may have knocked loose an inductor coil or capacitor in the process resulting in this issue so I took my phone apart and inspected it with a microscope. To my dismay I noticed something was indeed missing from my logic board but it wasn’t the blue inductor coil....

Chosen Solution i can pickup neighbors wifi networks. like 8 of them. but i can turn on my wifi hotspot and ps3 does not see it. helppppp!! Check your WiFi hotspot settings: First with so many active AP’s around you your hotspot maybe set for the same channel(s). Using your PC and a WiFi sniffer (google - stumbler for a free PC util) you should be able to isolate out a few channel or two....

Chosen Solution Novatel Mifi 2200 when I try to power on, there is no light on the power switch. Could it be the battery is dead? I plugged it in, pushed the power button but no light. I took the battery out pushed the power button 5 seconds and put the battery back in and pushed the power button for 5 seconds, still no light. If the battery is dead how long will it take to see a green power light when I plug it in?...

Chosen Solution My battery in my iPhone 5 is going dead really quick so I bought a 3rd party battery. I took out the old battery and put the new one in, but my iPhone 5 won’t turn on now. When I plug it in to an outlet or my Windows computer, the phone just flashes the Apple logo. I’ve tried putting the phone into DFU setting and then plugging it in with iTunes open, but when iTunes tries to restore the phone, the phone turns on and still flashes the Apple logo....