Posts

Chosen Solution About 2 months ago, I was charging my iPhone 7 with one of those knockoff braided lightning cables (I don’t usually do this, I didn’t have my genuine lightning cable on me at the time), and whilst charging my iPhone I noticed something strange this time, that strange thing being that my iPhone was fluctuating from charging to not charging continuously. This continued for about lets say a minute, until suddenly, my phone would not register the knockoff lightning cable....

Chosen Solution I put a battery into the iPod but it said it needs a wall outlet why? To finish the install of the firmware. Especially the older ipods required the wall charger with any repair as well as firmware updates. i.e. restore. You will see the apple icon coming on, a status bar will appear underneath it and subsequently this procedure will take all but a few minutes. Darn this is an old question…....

Chosen Solution When i push the keys in my key board, it wont register on my computer. I tried turning the computer on and off but the keys still don’t want to respond. Before you panic, make sure your keyboard is clean. Try wiping the space between keys or try to clean the keys with compressed air. It may also be a driver issue. Go into your computer’s control panel and navigate to the device manager....

Chosen Solution My Macbook screen suddenly flickering and can not see anything display, but if i plug in HDMI and export to other Screen display then both are woking fine. I have tried to change the IO chipset, display cable but the problem still the same. Someone ask me to change a new macbook display but it cost to much. Can anyone help to resolve this problem? Thanks. Your logic board has a problem within the Thunderbolt port....

Chosen Solution One of the edge pieces on my rubies cube is missing I need a new piece.What do I do? @the_nooba use this teardown Rubik’s Cube Teardown to remove the part you need. than you can purchases a used Cube from places like ebay etc. and replace the part you need.

Chosen Solution I was scrolling on Facebook and it glitched when I exited out of the video I was watching. This constent dimness happens constantly not sure what to do, always has stripes going up in down as the photo shows. There’s four lines same thickness as the apps on the screen. There’s cracked lines and I’m freaking out The screen needs to be replaced due to physical damage, it usually shows that after dropping the phone....

Chosen Solution My speaker stopped working after 40-45 minutes of use, I was listening to music, my phone was still on, and my phone was still connected to Bluetooth, suddenly the speaker stopped. First you need to check if your speaker’s battery is fully charged. If the battery is ok, check the settings on the device you are using to transmit the music or the application. In some cases when the phone goes into idle it will automatically disconnect to the speaker....

Chosen Solution My laptop powers up, but the screen is black. Hook up an external monitor to determine if you have a motherboard or LCD problem. If the external monitor works, the trouble is with the display or its cables. You should also confirm that your memory is properly installed, and you may want to replace your BIOS battery. I have included a link to disassembly instructions for your unit. Good luck....

Chosen Solution hi how to get Nand SN and other infos like country code, wifi Mac address if the iphone has problem in Nand & need to be replaced using Naviplus pro For the iPhone 6 I don’t believe you need the Mac address. It is critical for the 6S and later. As for the S/N and country and other info, and even Mac address, the Navipro will extract them from the NAND unless it is damaged beyond repair and beyond the ability of Navipro to read it....

Chosen Solution Hi I just put on a new glass and digitizer on my lg g2 phone, but when I turn it on, it still shows the cracks and black spots there were on the old screen, and the new glass is not broken at all…very strange…why does it do that??and what can I do?? Glass and digitizer is basically only the touch screen and glass but not the LCD. It sounds like the LCD is no good judging from what you said....

Chosen Solution Hello everybody! I have a problem with my MacBook. I’ve replaced the lcd with a new one: when I turn on the Mac, I see a very very soft image on the display. The back light doesn’t work… Anybody has an idea of what can I do? Is there any fuse or similar to check? Thanx in advance for who will answer to my question! And if you need more information, don’t hesitate to tell me!...

Chosen Solution I have an A1708, macbook pro 2017 non touchbar. It currently doesn’t have an SSD in it. I wondered why I can’t boot it? I plug it in and it makes the charge sound, but nothing on display, not the charge sign at all. The screen has been tested elsewhere and works fine. I wondered if it needs the SSD in it to actually boot? It also illuminates on the caps lock key but not illuminates keyboard....

Chosen Solution no odometer illuminate, can’t see milage Here is a link to aforum discuion and cure for your problem Good luck Ralph http://www.realworldautomotive.com/forum… Try pressing the ODO/Trip ODO button first. It resets the circuit. My light came back on as soon as I tried it. It will save you much time and headache! just a couple of bad resistors, cost me $1 for a pack of 5, and you only have to replace 4 of them....

Chosen Solution I have tested all the pins on the fpc connector and tested the meson voltages currently im looking at the cumulous ic but i havent done this before. Is there any suggestions to where the fault may be? looks like some sort of red gunk under the meson chip was to blame

Chosen Solution hi i have one imac a 1224 and non video on the screen The diagnostic led on the logic board are 1on, 2 on 3 on but there isn’t install the video card because the led 3 is every on my logic board is dead? please answare me dear Silvano LED Startup Sequence LED #1 = Power available. If no LED is visible: • Verify AC source • Verify known-good AC cable is connected • Verify cable connection between AC inlet and power supply • Verify cable connection between power supply and logic board • Verify power supply LED #1 + LED #2 = Power available, and system is powered on....

Chosen Solution After upgrading to iOS 4 and then iOS 4.2 wifi doesn’t work. Apple “genius” confirms it is hardware problem and would take about $350 USD to fix it or he said I could “go on line and get the part and fix it”. Any suggestions? I have read lots of others have this problem, though my Apple store manager denies this. You could downgrade it back to iOS 3....

Chosen Solution Hi, I have a OnePlus Nord CE 5G and the back cover is badly scratched. I wonder if it is possible to remove the scratches without replacing the back cover, but by polishing. I don’t know if the back is made of glass or if it is a form of plastic. Since I want to sell the device and its overall good state, I would rather not want to open it, risking damage to the internals....

Chosen Solution Hello! I’m changing my SSD on my Macbook Air. I bought a 1tb from macsales ‘OWC Aura SSD’. But when I put it in it won’t regonize the SSD. My current version is High Sierra 10.12.6. What can I do? I’ve been looking at enclosure to buy. But I don’t know which one to buy. The drive has to be formatted before you can install a system. Did you also buy the Envoy Pro that goes with it?...

Chosen Solution Model: Panasonic TC-P50X1 Service Manual PDF: https://data2.manualslib.com/pdf5/110/10… Service Manual Source(web version): https://www.manualslib.com/manual/109176… Backstory: Got this TV from a friend, TV did not turn on initially, no signs of power. First thing I did was checked fuses on the p board(power supply) and it seemed one of them had blown. (Did some research and it seems this model of TV has problems with power surges blowing the p board.) I order the same exact fuses and re-solder a working one in place....

Chosen Solution No sound or video, but backlite is on Hi @mjackerman , It’s looking like a mainboard problem. Here’s a link to the service manual (I think). It has troubleshooting flowcharts, which may be of some help