Chosen Solution Please can you help me. The connector for the PRAM battery on the on the board is broken. Now I have to braze it and I hope I can manage this. Can you tell me which point on the board is for the red and which is for the black cable. The red one goes left, the black one goes right. you can see it in step 14 &15 of the pram battery guide here comes your picture with some artistic photoshopping ;-)...
Chosen Solution In the Question below is my Problem and i will need help to fix it. But i am not good in repair something else. Can it be that a cable is broken or what could it be? Please help me. For my poor english,i´m from germany ;-)DS You have a short somewhere in the cable that the trigger switch is attached to. Here is the part You need. Here are instructions on how to replace the part....
Chosen Solution Few month ago i spilled chocolate milk on my ipad I left it alone for a few days and it works again But it remains some problems First, left speaker sound died down Second, my home button doesn’t work except touch id Third, if i reboot my ipad while connected to the cable, my ipad turn into a brick until disconnect a cable and reboot again it And the most important problem is it was rebooted rarely but these days it happens a lot What parts should i replace?...
Chosen Solution So, I’ve recently bought a GTX 1660 gaming oc 6gb, I’ve installed the graphics card, but since my monitor doesn’t have a hdmi port, I bought a hdmi to vga adapter, but when I turn my pc on, my monitor just says no input signal. I’ve updated my BIOS to the latest version I could find, I’ve tried rearangeing the ram sticks, and I’ve tried to take out and put back in the gpu lots of time, but none of this seems to help ....
Chosen Solution I dropped my phone is water, it briefly switched on and later died. I have opened the phone, changed the battery, but still nothing. I can see there is some (water marks) under the logo board. How can I fix my phone without losing my photos etc. Because I didn’t back up in iCloud. :( Any help would be appreciated I’m trying to fix myself as repair shops want to charge me a bomb!...
Chosen Solution My power button hasn’t worked for the past half year. I think something must have broken inside over time, because it doesn’t “click” properly anymore, no matter how hard I try. Maybe the spring inside is broken, or something similar. I’ve managed to go this long without turning it off, but last night I went to bed with a low battery and plugged it into a faulty charger, thinking it would start charging, only to find out the next morning that it hadn’t, and the battery had run dry overnight....
Chosen Solution I’ve recently bought this used controller, everything else but my right analog stick is fine.It must’ve been dropped that the stick has to be pulled up if pressed down. While it’s stuck down my game is slightly moving up (Example: while the thumbstick is stuck in place, as I’m playing a first-person shooter, the character starts to look up.) Anyone know if I either have to change the thumbstick or there’s something inside that’s broken?...
Chosen Solution When I was changing the battery I had to unplug the top ribbon that holds the aux, cameras and power button and now ive plugged it back in the whole top ribbon doesnt work what could I have done or fix it? To add to that now it doesnt turn on at all after Ive closed it to make sure its properly plugged in TheBlooner AceTin, Unfortunately, even though it might be a pain, you’ll have to open it back up again!...
Chosen Solution Hi! iPhone 7 after a hard fall does not see home button anymore. I have a screen with good working home button so I know the home button works but when i attach screen the home button not works. NO touch ID, no Pressure sensing nothing…. Can someone point me in the direction what to check on the PCB board please? Thank you. From the 7 series up you cannot replace the home button with another one....
Chosen Solution When I was setting up the device one of my antenna broke, Is it possible that the router works like that, or do I need to replace the antenna? Hi, Where exactly is it broken? Has the connector port on the top of the router been broken or just the antenna itself? If it is the port connector then there may possibly be more damage inside the unit. If it is just the antenna that has broken and not the connector port, then it depends on which antenna has been affected....
Chosen Solution I have just recently done a ‘screen’ and ‘battery’ repair on my Hauwei P9. I managed to replace the screen and I am able to use my phone again, YAY! but… Ever since I replaced the screen and battery I am now having a major problem. First of all, it kept coming up with a message saying, “Temperature too high, functionality limited”. After noticing this message I noticed the lightning bolt charge symbol had disappeared....
Chosen Solution In the process of removing the logic board the power switch cable was unintentionally ripped from the back of the power switch. Is there any way to remove the switch so I can attempt to resolder the wire to the switch? That switch is usually held in place by 3 plastic globs that are integrated into the back frame. I have used a chisel to break them off and then re-glued it back into place after replacing....
Chosen Solution It idles fine but when you give it as it bogs down and tries to die. @notamechanic, Robert, Possibly could be a plugged catalytic converter, but there are also a lot of other things that also could cause this such as bad sensors TPS, MAP, MAF, IAC, O2, failing knock senor, faulty injectors, dirty throttle body, EGR valve, major vacuum leak, failing fuel pump, bad ignition, bad distributor, etc....
Chosen Solution Bought a Nikko landshark without battery. So i connected a other i had lying around an put it to on. IT moved for couple of minutes and the it stuttered and stops. The battery is now recharged and is does not want to move.. I dont see lose wires or anything burned and dont smell anything. Does somebody knows wat the problem can be? Dennis the original battery was a 6....
Chosen Solution I plug in my phone and it shows charging but it does not go out, it remains the same I changed battery but it still the same Likely you use poor quality aftermarket chargers, and have damaged your phone. Try replacing the Lightning dock. Apple or Samsung brand chargers bring your phone the 3.8 volts that the phone wants. The after market ones bring the full 12 coming out of the wall iPhone SE (1st Gen) Lightning Connector and Headphone Jack iPhone SE Lightning Connector Replacement
Chosen Solution Hello, I’m running on iOS 9.3.2. When I charge sometimes it happens when I let my iPhone charging and after remove it from charge it will get stuck at one battery percentage (not decreasing as I use it) untill I reboot the phone then it shows the correct percentage. Thanks to help me *Sorry for bad english ? Hi, Have you tried replacing your battery? The gas gauge may be damaged in the battery (what tells the phone how much percentage is left) If replacing the battery doesn’t solve your issue it will be a further issue, this may happen if you have used cheap charging cables etc....
Chosen Solution How do i enable my disabled apple ipad2 without computer or itunes There is no way to enable a disabled iPad without a computer. If you can use a friend or family members internet enabled device and can access www.icloud.com/find it is possible to remotely erase your device by following the instructions below. The following instructions are from Apple’s Support Website If you set up Find My iPhone on your iOS device or Mac, you can use iCloud to erase and restore it....
Chosen Solution I am having the same problem. Tried cleaning the pads, did not work. Bought a replacement part and it worked….for 4 loads and then the same problem on the replacement panel! Very strange. Very frustrated, now I am out $250 for the replacement panel too. Are there any other ideas on what this issue is and other possible solutions? Update (10/27/2021) Hi Jeff, thanks for the reply. Model MVWB835DW3....
Chosen Solution Hi guys, I recently bought a brand new iPhone 6s 128GB off eBay (so no warranty). I found some dust inside the camera lens so I followed the guide here on iFixit and wiped it clean. However, after that, the phone screen near the volume down button is clicking. It feels subtly loose, and there’s a “click” sound every time I press it. It doesn’t hamper the functionality of the phone in any way, but it just feels cheap and tacky, not something I’d expect from an iPhone....
Chosen Solution My phone works, but my screen won’t show anything. It is blank or black. What can I do to fix it? Hello, Recently I had a same problem. My phone (Samsung Galaxy E5) screen goes blank/black but the buttons (power, home) and bottom lights are still working. Strangely, the phone works just like usual. It still can receive calls, messages, chats or any notifications, but the screen is black/blank maybe that’s caused by some system problems/errors that affect the screen....
