Chosen Solution Is it possible to remove the baseband chipset and have the iphone still function as a WiFi only device? No. Your phone may boot but when you try to update or reinstall iOS, it will be stuck in recovery.
Chosen Solution We are a repair shop and have stockpiled quite a few broken displays for Macbook Pros of all years and flavors. Someone said they thought PowerBookMedic.com offer money for broken displays, but I didn’t find that to be true. Does anyone know of a place that offers anything for old broken displays? As you’d expect, some are cracked with bad LCDs, some are just cracked. Some only show a backlight glow....
Chosen Solution Hi, my washer made a lot of noise during the drain cycle, then spit out grey-like sand from where the water drains into the sink. this looked like bits of chewed up plastic with a gravel-like consistency. The washer kept thumping and not sure if I smelled something burning or it was just my anxiety at having to buy a new washer! The washing inside had tiny dark grey bits over it....
Chosen Solution No surprise, I’ve damaged my force touch gasket while replacing the battery on my 44MM series 4 watch. The watch has been dead since before WatchOS 7 so is still on the last major release. Any thoughts on whether the device could be re-assembled with a damaged Force Touch gasket and will operate enough to install a new OS since the feature is disabled? The easiest way to test this is to put the screen back on....
Chosen Solution My cable got heated and burnt.. i took it off immediately the display showed charge battery But the charging port isn’t working, what are all the possibilities that can be caused..? There’s a good chance that the phone sustained some extensive damage. However, without knowing if the issue is caused by a bad charger/cable or a logic board issue, it’s hard to say what exactly is at play. You’ll need to consider that the charge port and/or battery could have been damaged in the process so you’ll need to eliminate those possibilities before looking at potential logic board issues....
Chosen Solution My iPhone 7 plus has a cracked screen and very poor battery life so I ordered a replacement screen and battery to repair in my free time. Unfortunately before I got the chance to the screen all of a sudden turned black and subsequently is stuck in a boot loop. I have put it in recovery mode and connected to my Mac and tried to restore and also update it after that restore / update finishes it remains in the boot loop SOMEONE PLZ HELP!...
Chosen Solution My pants are too long; how do I hem them? Check out or hemming guide! Note that if you are hemming denim jeans, you’ll need a denim needle. If you want the classic denim look, you’ll also need some thick, gold thread and a double needle.
Chosen Solution I usually listen to my ipod on one of the docking stations while I am in the shower… but one day when I took it off and plugged in my headphones I could not turn off my ipod and I could not use pause/ play button at all. I have tried resetting it and it didn’t do anything. I have also tried sticking it in rice thinking maybe it got in the play button… I am not quite sure if it did, but it is possible since I play it while I am showering....
Chosen Solution hi,first of all my English isn’t very good,sorry for that. my phone (Sony Xperia S (LT26i)) is dead and i can’t turn it ON it also can’t keep his charge even sometimes it was charging. So i decided to change my battery. I bought a BA800 battery and change it myself according to a video i saw on YouTube. after all my phone doesn’t start up even i plug in it to adapter....
Chosen Solution When i push in my power button it wont move. Without this I cannot control whether or not my tablet is on or off. PLEASE HELP ME!!! Dissemble your device and see if there is anything in between the power button and motherboard. There may be a connection problem between the power button and the mother board. If this is the issue, you may use this guide to replace it....
Chosen Solution Hi a few days ago I dropped my phone and cracked it in a few spots. Yesterday I paid $100 to get it fixed. When it was done, I noticed my screen is now tinted a bit yellow and the quality is way worse. Pictures are now yellow and fuzzy, and the camera has awful quality. Is there a way to go back to the original quality/color of my phone?...
Chosen Solution Every time I move my right analog stick to the right, it gets stuck. Can someone help? Hi I would suggest you to open up to check if there are any debris stuck inside. Unsticking Steelseries Nimbus Triggers you might need to apply a little wd-40 inside else if it does not works well, you will need to find replacement from ebay / aliexpress for parts. you need to desolder and solder on the new part....
Chosen Solution I replaced my battery with one from iFixit, but it still drains fast and will get hot. It will drain overnight every time if not plugged. It also turns off by itself and I have to do a hard restart. When it does restart the battery will say it is at 30%–not at 2%. I have turned off all background apps and even turned off the Mail function (and retrieving mail through Gmail app) Thoughts?...
Chosen Solution Hello. After repairing a broken glass from an iPod touch 4, the backlight seems to disappear. Now have no backlight at all. Any suggestions? What could had been wrong? Thanks Try to check your LCD connection that no pins are bent. Reseat the connector. That connector is very fragile and always be gentle when seating the connector as you can bend pins. Take a look at why I once lost backlight on a 4g Touch: https://www....
Chosen Solution will power on no audio Just a popping sound from the device @edward422 try some external speakers and see if that makes a difference. Also, check your audio setings. If none of that makes a difference, it is possible that you have issues with the audio IC’s. Unplug the TV and disassemble it, then take lots of pictures of the boards and post those with your question. That way we can see what you see....
Chosen Solution i just got a secondhand iphone5 (only 3 months old) and theres only sound on the left bud.. i tried all options in the settings but the problem persists.. when i pull out the headphone plug slightly (about 3millimeters) and press it sideways, i get stereo sound.. i tried cleaning the jack but that didnt change anything either :/ pls help!! 0_o dre, “i pull out the headphone plug slightly (about 3millimeters) and press it sideways” sounds like a bad audio jack....
Chosen Solution Bad connection inside buttons, how do I, clean/repair this? Just to clarify, is your phone not turning on at all? Or is it an intermittent issue? To test whether it’s your power button or another issue, remove your charged up battery and insert it in. If it is the power button that’s the issue, (and not the board), then the phone will turn on anyway. If it doesn’t turn on, then you may have another issue....
Chosen Solution Two lines appear on original when using the paper feeder. How does one clean the rollers or belts? Check how much waste ink is in the service station on that printer, if you can do this. Open the ink replacement area on the printer and use a high-power flashlight to make sure you can see. If you see a good amount of ink there (or it’s full), it’s coming from there....
Chosen Solution I have changed the roller and fuse as it was blown but paper getting stuck between them and under cartridge printer says jam in cartridge area. Make sure the fuser is seated and check to see if the fuser rollers turn. Does the paper get crumpled on the leading edge? Does the paper show print? If the paper shows printing then the toner cartridge is OK, if it doesn’t show printing then pull the toner cartridge out and open the flap and see if there is an image printed on it; if it is blank then the toner cartridge could be defective or the gear assembly driving the toner cartridge has failed....
Chosen Solution Hello, I have just built a new PC over weekend, however when I press the power button the PC boots for a split seconds then shuts down does this for around 30 seconds to a minute then boots up as normal. If i reboot then depending if it doesn’t shut down fully i am OK. originally i wasn’t getting any Display when first built and I noticed one of the Pins were bent and managed to straiten it out with a needle do you think this is still an issue?...
