Chosen Solution
Hello. I have just replaced a iPhone 6 screen. Now it shows a quick red screen, and afterwards going to “plug in itunes” logo. I have tried to put it on DFU mode, but still not working. I tried this before, but after restore in DFU mode it works fine, but not this time. The error that pop up on itunes is 4005, and 4013. Anyone have some solutions? Greetings Christian Update No one have any solution?
If you did not mix up your screws when re-installing the shield that covers the screen connectors: try disconnecting the front cam assembly cable from the logic board, then try restoring again. What happens? If you did mix up your screws, you may have a case of long screw damage. You’ll need to confirm by examining the screw brackets under a scope. Try at least to remove that shield, then test your phone. Any change?
