Chosen Solution
After replacing new ink cartridge, the printer still indicate low ink?
there is a little gear which can get out from it place in time. Check its position and if its moved - use a glue to hold it at place.
here is an example of wrong position of the gear:
If you can’t figure out where is the gear in a printer - look at the bottom right corner of the picture:
If you need a replacement part: google tne next text “pinion gear 10T 0.3M bore 1.5mm”;also spare parts for RC helicopters can be applied, for example MH-BP031015
I solved this problem but printer stiil give the same message. Any ideea? Many thanks!
Done! The gear was still there but it was almost totally off the shaft. I applied a small dab of Gorilla glue in the gear and pressed it back on. And now I have a printer again!
Awesome! Stuck some gaffa tape to the metal on the far side - good for now!
Thank you! Worked for me as well for a newer model CP-1200 !
